Then, restart your computer and Windows 7 will reinstall all USB controllers automatically.
Repeat the step 2 to uninstall all items under "Universal Serial Bus controllers".
In Device Manager, double click to expand "Universal Serial Bus controllers", right click on the Host Controller, click "Uninstall" and click "OK".Ĭheck if at all there is an exclamation mark along the driver, it suggests issues with the driver installed.ĭ. If you are prompted for an administrator password or for a confirmation, type the password, or click Allow.Ĭ. Note: If Control Panel is in Classic View, double-clickSystem, and then click Device Manager. Click System and Maintenance, click System, and then click Device Manager. Click Start, and then click Control Panel.ī. If it does not help, then use steps in method 2.ĭisconnect all USB devices and then perform the following steps:Ī. Hardware devices are not working or are not detected in Windowsĭiagnose and fix Windows USB problems automatically Please run these Microsoft Fixit and check the issue. I would suggest you to try following methods and check if it helps. Does Jungo connectivity appear under Universal Bus service(USB) devices? I would like to know some information about the issue so that we could help you better.ġ. Thank you for posting your question on Microsoft Community. Thanks for taking the time to read through my question. I assume that I did not sufficiently remove all the driver components to trick my PC to re-installing the drivers as though this was my 1st attempt.Ĭan anyone tell me how I can purge all the remnants of these drivers so that I can attempt a successful re-install?
I assumed this might be enough to allow the driver to automatically install when I restart my PC and plug in the programmer but this is unfortunately not the case. I can easily right-click to uninstall WinDriver but not JungoĬonnectivity. When I view the contents of Jungo, I see another driver called "WinDriver". When I go into the Device Manager, I can see an entry for "Jungo Connectivity" which has a drop-down arrow beside it. According to the ATMEL discussion groups, this driver sometimes doesn't install correctly on the 1st attempt, needs When I first plugged this programmer into the USB of my PC, it automatically installs a USB plug & play driver called "Jungo Connectivity". I recently purchased an ATMEL development system (i.e. I'm new to this forum and I tried unsuccessfully to locate a similar question.